JWST Near Infrared Camera

The JWST Near Infrared Camera (NIRCam) offers imagingcoronagraphy, and grism slitless spectroscopy from 0.6 to 5.0 μm, as well as wavefront sensing measurements for JWST mirror alignment.

On this page

The JWST Near Infrared Camera (NIRCam) observes from 0.6 to 5.0 μm and offers imagingcoronagraphy, and grism slitless spectroscopy. NIRCam has 2 modules pointing to adjacent fields of view. Each module uses a dichroic to observe simultaneously in a short wavelength channel (0.6–2.3 μm) and a long wavelength channel (2.4–5.0 μm).

 NIRCam has 5 observing modes for science:

NIRCam will also obtain wavefront sensing measurements used to align and phase JWST's primary mirror.

Figure 1. NIRCam field of view in the JWST focal plane

NIRCam in the JWST field of view

Observational capabilities

Each observing mode offers distinct capabilities and uses a subset of the optical elements available in the pupil and filter wheels.

Table 1. NIRCam observing mode parameters

Observing mode


Field of view§





2 × 132" × 132"
(44" and 5" gaps)

0.031FWHM 2 pix
at 2.0 µm

2 × 129" × 129"
(48" gap) 

0.063FWHM 2 pix
at 4.0 µm



20" × 20"


Wide field
slitless spectroscopy
2.4–5.0 2 × 129" × 129"0.063R ~ 1,600 at 4 µm
Time-series imaging0.6–2.3 

129" × 129"
132" × 132"


Grism time series2.4–5.0129" × 129"0.063R ~ 1,600 at 4 µm

§ Smaller fields of view are available using subarrays in the imaging, time series imaging, and grism time-series modes.

Field of view

Figure 2. NIRCam modules field of view

NIRCam field of view

The 2 NIRCam modules image a 5.1' × 2.2' field of view with a central gap of 44"—the 2 adjacent 2.2' × 2.2' fields cover 9.7 arcmin² in total. The coronagraphs obtain images in regions of the sky outside the imaging/grism field of view. These are projected onto the detectors by optical wedges located on the pupil plane Lyot stopsCurrently, NIRCam coronagraphy is limited to Module A only.


NIRCam consists of 2 redundant modules—A and B—with identical optical elements and nearly identical throughput. The NIRCam observing modes include options to use either a single module or both simultaneously with identical integration times, readout patterns, and filters.


Each module includes a short (0.6–2.3 µm) and long (2.4–5.0 µm) wavelength channel. NIRCam uses a dichroic to observe at both wavelengths simultaneously in roughly the same field of view.

Table 2. Properties of short and long wavelength channels

Short wavelength channelsLong wavelength channels

Wavelength range

0.6–2.3 μm

2.4–5.0 μm

Fields of view

2 × 2.2' × 2.2' (with 4"–5” gaps)

2 × 2.2' × 2.2'


8 × 2040 × 2040 pixels

2 × 2040 × 2040 pixels

Pixel scale




0.064" @ 2μm (Nyquist)

0.13" @ 4 μm (Nyquist)

Grism slitless spectroscopy


R ~ 1600 at 4 μm

Coronagraphic occulting masks

round: 2.1 μm

bar: 1.8–2.2 μm

round: 3.35, 4.3 μm

bar: 2.5–5.0 μm

Not including reference pixels insensitive to light that are 4 pixels along each outer edge.
PSF undersampled at lower wavelengths; slightly broader for coronagraphy.

Optical elements

Each channel includes a pupil wheel and a filter wheel, each with 12 optical elements, which may be used in various combinations. These elements include:

  • Filters with extra-wide, wide, medium and narrow passbands;

  • Coronagraphic Lyot stops to suppress light that passes the occulting masks;

  • Grism elements for slitless spectroscopy in the long wavelength channel;

  • Weak lenses to defocus light from bright sources to avoid detector saturation, also used for the telescope alignment.

Within each module, light may (optionally) be passed through a coronagraphic occulting mask (in the focal plane) before being divided by the dichroic beam splitter to the short and long wavelength channels.

Figure 3. NIRCam pupil and filter wheels

The NIRCam pupil and filter wheels contain a total of 48 optical elements. Filters are color-coded by wavelength. Wider filters in the figure appear more transparent than narrower filters.


The 29 NIRCam filters have names "Fnnnx" where "nnn" refers to the central wavelength (e.g., 220 for 2.20 µm) and "x" refers to the filter width: "W2" for extra-wide (R ~ 1), "W" for wide (R ~ 4), "M" for medium (R ~ 10) and "N" for narrowband (R ~ 100).

Figure 4. NIRCam and JWST optical telescope element (OTE) filter throughputs

NIRCam and JWST Optical Telescope Element (OTE) filter throughputs (version 4.0: April 22, 2016). The vertical gray bar marks the approximate dichroic cutoff between the short and long wavelength channels. Filters marked "P" are located in the pupil wheel, requiring transmission through a second filter in the filter wheel, either F150W2, F322W2, or F444W. In those cases, the combined transmissions are plotted.


NIRCam has 10 Teledyne HgCdTe H2RG detectors, or sensor chip assemblies (SCAs), each with 2040 × 2040 pixels sensitive to light. Eight short wavelength detectors cover roughly the same area on the sky as the 2 long-wavelength detectors. In full frame imaging mode, all 10 detectors are read out non-destructively every 10.74 s. The smallest supported science subarray (64 × 64 pixels) can be read out in 49 ms (the shortest exposure time).


In a 10 ks image, NIRCam will obtain S/N = 10 detections of point sources as faint as ~10 nJy (AB mag 28.9) in some filters, and S/N = 5 detections of 5 nJy (AB mag 29.65) point sources. See NIRCam Imaging Sensitivity and NIRCam Sensitivity.

Please use the Exposure Time Calculator (ETC) for the most up-to-date sensitivity estimates for specific proposed observations. See the NIRCam Sensitivity page for more information.

Figure 5. NIRCam sensitivity for imaging

Approximate sensitivity of all NIRCam filters

Sensitivity is shown as S/N = 10 detection limits for point sources in a 10 ks image (comprised of 10 exposures, 1 ks each). The sources are assumed to have flat spectra in nJy (and AB magnitudes). Zodiacal light is assumed to be 1.2 times the minimum. Filter widths are shown as horizontal bars. Extra-wide/wide, medium, and narrow filters are labeled in normal, bold, and italic text, respectively each with progressively thicker bars. Please use the Exposure Time Calculator (ETC) to calculate sensitivity estimates for your specific proposed observations.


NIRCam's brightest saturation limits are achieved in the time-series observing modesWeak lenses (at short wavelengths) and grisms (at long wavelengths) spread the bright light over more detector pixels. Subarrays allow for shorter readout times. Stars observable without saturation (80% full well) include those visible to the unaided eye: ~5th magnitude or brighter, depending on the observing mode, wavelength, and configuration.

Approximate saturation limits are given in the time-series imaging and grism time-series pages. Please use the ETC to calculate saturation estimates for your proposed observations.

Data calibration and analysis

Information about calibration is available in the JWST Data Calibration Considerations article. This article and its links point to content about absolute astrometricflux, and wavelength calibration, as well as information on calibration reference files.

Details about the data can be found in the Understanding JWST Data Files article. The JWST calibration pipeline is described in both the JWST Science Calibration Pipeline Overview article and the official software documentation. More information about post-pipeline processing can be found in the JWST Post-Pipeline Data Analysis article.

External NIRCam links and documents

STScI NIRCam website

University of Arizona NIRCam website

NASA NIRCam site


JWST Community Lecture Series - NIRCam: Your Next Near-Infrared Camera (M. Rieke)


NIRCam was built by a team at the University of Arizona (UofA) and Lockheed Martin's Advanced Technology Center, led by Prof. Marcia Rieke at UoA.


Rieke, M. et al. 2005, SPIE, 5904, 1
Overview of James Webb Space Telescope and NIRCam's Role

Rieke, M. et al. 2003, SPIE, 4850, 478
NGST NIRCam Scientific Program and Design Concept

Beichman, C. et al. 2012, SPIE, 8442, 2
Science opportunities with the near-IR camera (NIRCam) on the James Webb Space Telescope (JWST)

NIRCam Papers from the August 2005 SPIE meeting

NIRCam Technical Documents 

Latest updates
    Merged this page with NIRCam Overview

    Updated grism resolution

    Updated pixel scale values.
Originally published